Dériveur de classe internationale : FLYING DUTCHMAN
FD
Bootswerft Mader
- 6.05m 
19' 10"ft
• hull built with epoxy resin, double layer kevlar and
foam sandwich construction
• Deck built with epoxy resin and honeycombscore
• Double bottom troughout with draingstubes, leading to the transom
• Front cockpit bulkhead y-shaped
EQUIPMENT
• Proctor E-mast
• Proctor main boom with 1 spinnakerpole
• SpiRo fitting in front of the mast belaying stb on the front deck
• adjustment fore and aft for centreboard with stopper,adjustment up and down continous with rope
• adjustment for the shrouds with metal ballbearing blocks 1:24
• jib tensioner with open tackle for rough and fine adjustment 1:24
• Ronstan cord jib furler
• adjustment for the lower shrouds with Harken blocks 1:16
• jib sheet adjustment with Harken ratchet blocks
• continous trapez
• spi luncher with a net tube
• all blocks ballbearing
• barber hauler belaying in the front, at the edge of the cockpit, or in front of the traveller on the cockpit inside
• revolving block for the main sheet by Harken
• centreboard and rudder made of fiberglass, with
epoxy and additional carbon fiber reinforcement
• shrouds, jib tensioner, cunningham, control lines for the lower
• shroud and the vang lead outside. Belay either on a bracket on the double bottom or on a cleat board in the front of the traveller
• small Tacktick compass with support
19' 10"ft
• hull built with epoxy resin, double layer kevlar and
foam sandwich construction
• Deck built with epoxy resin and honeycombscore
• Double bottom troughout with draingstubes, leading to the transom
• Front cockpit bulkhead y-shaped
EQUIPMENT
• Proctor E-mast
• Proctor main boom with 1 spinnakerpole
• SpiRo fitting in front of the mast belaying stb on the front deck
• adjustment fore and aft for centreboard with stopper,adjustment up and down continous with rope
• adjustment for the shrouds with metal ballbearing blocks 1:24
• jib tensioner with open tackle for rough and fine adjustment 1:24
• Ronstan cord jib furler
• adjustment for the lower shrouds with Harken blocks 1:16
• jib sheet adjustment with Harken ratchet blocks
• continous trapez
• spi luncher with a net tube
• all blocks ballbearing
• barber hauler belaying in the front, at the edge of the cockpit, or in front of the traveller on the cockpit inside
• revolving block for the main sheet by Harken
• centreboard and rudder made of fiberglass, with
epoxy and additional carbon fiber reinforcement
• shrouds, jib tensioner, cunningham, control lines for the lower
• shroud and the vang lead outside. Belay either on a bracket on the double bottom or on a cleat board in the front of the traveller
• small Tacktick compass with support
